How-to / SOLIDWORKS

How to draw a squircle, a Reuleaux triangle or a polygon with curved sides in SOLIDWORKS

The Polygon tool only draws straight sides. A squircle, a Reuleaux triangle or a hexagon with bulging sides is drawn by hand: one arc per side, a construction polygon, and Equal, Coincident and Tangent relations until the shape is fully defined. Arc Polygon places such a shape with three clicks and writes the same native arcs, relations and dimensions for you.

Video (0:36, English): Squircles, stars and flower shapes in three clicks in SOLIDWORKS. Also on YouTube.

Doing it by hand

  1. 01Draw a regular polygon as construction geometry (Polygon, For construction).
  2. 02Draw a 3 Point Arc over every side, from corner to corner.
  3. 03Select all arcs and add an Equal relation, so every side has the same radius.
  4. 04Dimension one side length and one arc radius. For rounded corners add a Sketch Fillet at every corner and keep the radii equal.
  5. 05Check that the sketch is fully defined, and that no arc flips to the other side when you change a dimension.

Which shapes these are

  • A squircle as designers usually draw it: four equal arcs with rounded corners, between a square and a circle.
  • A Reuleaux triangle: three arcs, each centred on the opposite corner. It has the same width in every direction.
  • A lens: two arcs.
  • Polygons with sides that bulge outward or curve inward: flower shapes, stars with curved sides, soft hexagons.
  • Not a superellipse: that curve has no arcs. For the mathematical squircle use an Equation Driven Curve.

Three clicks with Arc Polygon

  1. 01Inside an open 2D sketch: SWPlugins Suite tab › Arc Polygon. Set Sides (2 to 60) and, if wanted, a Corner radius.
  2. 02Click the centre. A sketch point or the origin under the cursor is picked up.
  3. 03Move out and click a corner: this sets the size and the rotation. Near level the shape snaps.
  4. 04Move again and click to set the curve of the sides: outward, inward or straight. The yellow preview shows the shape the whole time.
  5. 05The shape is written into the sketch as arcs, construction lines and relations. With Add dimensions it gets driving dimensions for the side length, the side radius and the corner radius.

Good to know

  • With the dimensions and a fixed centre the shape is fully defined: change one dimension and the whole shape follows.
  • It is plain sketch geometry. The sketch opens and solves on any SOLIDWORKS, with or without the add-in, and needs no licence.
  • One Ctrl+Z removes the whole shape.
  • For a Reuleaux triangle set the side radius equal to the side length.

Try it on your own part

Arc Polygon is part of Advanced Sketching, a module of the SWPlugins Suite, a SOLIDWORKS add-in (2023 or newer). Every tool works free for 14 days; a licence is €149.25 plus VAT for the whole Suite, single modules from €44.25 (launch price until 30 November, regular €199 and from €59), one-time.

Docs: Arc Polygon

Questions

Related