Launch price until 30 November: 25 % off the Suite and every module, applied automatically at checkout
Docs / Arc Polygon

Arc Polygon

Draws a regular polygon whose sides are arcs in a 2D sketch: a squircle of four arcs, a rounded triangle like a Reuleaux triangle, a lens. Placed with clicks like the rectangle tool, optionally with rounded corners, and built from native arcs with relations and dimensions.

Where to find it

Inside an open 2D sketch: SWPlugins Suite tab › Arc Polygon. Drag the command into the Sketch toolbar with Tools › Customize if you use it often.

While the tool is active the shape follows the cursor as a yellow preview. Nothing is added to the sketch until the last click.

Placing a shape

  1. 01Click the centre. A sketch point or the origin under the cursor is picked up.
  2. 02Move out and click a corner: this sets the size and the rotation. Near "bottom side horizontal" the shape snaps level. You can also press at the centre, drag and release at the corner.
  3. 03Move again and click to set the curve of the sides: outside the straight polygon the sides bulge outward, inside they curve inward, and close to it they stay straight.
  4. 04The shape is written into the sketch and the tool is ready for the next one. Close the page to end.

Options

SidesThe number of sides, 2 to 60. Two sides give a lens.
Corner radiusRounds every corner with an arc tangent to both sides; 0 keeps the corners sharp. A shape too small for the radius gets the largest one that fits, and the page says so.
Third click sets the curveOff: the corner click finishes the shape, with the curve of the last shape you placed in proportion.
Horizontal relationAdds a Horizontal relation to the bottom side when the shape was placed level.
Add dimensionsAdds driving dimensions for the side length, the side radius and the corner radius.

What you get

  • Plain SOLIDWORKS sketch geometry: arcs (or lines for straight sides), construction lines from corner to corner, and relations that keep the polygon regular and the sides equal.
  • With the dimensions and a fixed centre the shape is fully defined. Change a dimension and the whole shape follows.
  • Nothing depends on the add-in afterwards: the sketch opens and solves on any SOLIDWORKS, with or without it, and needs no licence.
  • One Ctrl+Z removes the whole shape.

Limits

  • Redo after an undo brings the shape back one entity per Ctrl+Y, not in one step.
  • Sides that bulge far outward turn the corners into notches; their rounding then sits in the notch. A dimension change that turns notches into pointed corners (or back) leaves the roundings on the wrong side: place the shape again instead.
  • A regular shape only: all sides have the same length and the same curve. It is not a superellipse.