How to check curvature continuity (G2) between surfaces in SOLIDWORKS
SOLIDWORKS gives numbers for the gap (Check) and for the angle between faces (Deviation Analysis on the edges you pick); curvature continuity you judge by eye with zebra stripes, curvature display or curvature combs. Continuity Check measures every edge of a part at once, gap, angle and curvature jump, and draws each edge G2, G1, kink or gap.
G0, G1, G2 in one sentence each
- G0 (contact): the faces touch along the edge, nothing more; a kink is visible.
- G1 (tangent): they also meet at the same angle. A circular fillet next to a flat face is G1: the curvature jumps from 0 to 1/radius, which shows as a break in reflections.
- G2 (curvature-continuous): the curvature across the edge is the same on both sides too. Reflections run through without a break.
What SOLIDWORKS offers built in
- Check (Evaluate tab): among other things the largest edge gap and vertex gap of the bodies: G0 as a number.
- Deviation Analysis (Evaluate tab): the angle between the faces along edges you pick, with the minimum, maximum and average: G1 as a number.
- Zebra Stripes, Curvature display and Surface Curvature Combs: show G2 as pictures. Stripes that keep their direction and width across an edge, and colours or combs that run on smoothly, mean curvature-continuous; there is no number for how far off it is.
Step by step with Continuity Check
- 01Select the faces or bodies to check, or nothing for the whole part, then
SWPlugins Suitetab › Continuity Check. - 02Every edge is drawn in its colour: green G2, yellow G1, red for a small kink, magenta for a gap; sharp edges are left out. The message lists the worst edges and where they are.
- 03The Task Pane lists every edge with its gap, angle and curvature jump, worst first. Click one to see the curvature jump along it as hairs; double-click to zoom to it.
- 04Adjust the tolerances (defaults 0.001 mm, 0.05°, 2 %) to your standard: the edges are judged again at once. Save report… writes them all as a CSV table.
Good to know
- Surfaces that are not knit yet are checked too: an open edge is measured against the touching open edge of the other surface body.
- The curvature jump is measured across the edge, as a share of the larger side’s curvature; nearly flat faces count as flat, so two planes never show a jump.
- It changes nothing in the part and adds nothing to the feature tree.
Try it on your own part
Continuity Check is part of Advanced Surfacing, a module of the SWPlugins Suite, a SOLIDWORKS add-in (2023 or newer). Every tool works free for 14 days; a licence is €149.25 plus VAT for the whole Suite, single modules from €44.25 (launch price until 30 November, regular €199 and from €59), one-time.
Docs: Continuity Check
Questions
A circular (constant radius) fillet is tangent to its faces, but its curvature jumps from the face’s to 1/radius at the edge: G1 by definition. SOLIDWORKS’ curvature-continuous fillet option and fills or blends set to Curvature aim for G2; Continuity Check shows how close they get.
For visible consumer-product surfaces, a gap of 0.001–0.01 mm, an angle of 0.05–0.1° and a curvature jump of a few percent are common targets. A tangent break under about 0.1° is hard to see; curvature breaks show in reflections long before they show in a section.
No. It checks where two faces meet (and where open edges of separate surfaces touch). Kinks inside a single imported face are what SOLIDWORKS’ Geometry Analysis reports as discontinuous faces.