Launch price until 30 November: 25 % off the Suite and every module, applied automatically at checkout
Docs / Continuity Check

Continuity Check

Checks how faces join along their edges: the gap, the angle and the curvature jump on every edge, each edge drawn G2, G1, kink or gap. Also between surfaces that are not knit yet.

Where to find it

Select edges, faces or bodies, or nothing for the whole part, then SWPlugins Suite tab › Continuity Check (Surfacing). Every edge between two faces is measured and drawn in colour; the Task Pane lists them, worst first. It adds nothing to the part: the colours go when you close the page.

The colours

Green: G2Touching, tangent, and the curvature across the edge the same on both sides (within the tolerances): curvature-continuous.
Yellow: G1Touching and tangent, but the curvature jumps. A circular fillet next to a flat face is G1: its curvature goes from 0 to 1/radius.
Red: kinkTouching, but meeting at a small angle (more than the Angle tolerance, less than Sharp above): usually a fault.
Magenta: gapThe faces are further apart than the Gap tolerance along the edge.
Grey: sharpA deliberate edge (more than Sharp above). Hidden unless Show sharp edges is on.

Options

Edges, faces or bodiesWhat to check: edges, the edges of faces, or all edges of a body. Nothing picked: every edge of the part’s visible bodies. One edge picked: shown in detail.
Gap (mm)Default 0.001 mm.
Angle (°)Default 0.05°: up to it the faces count as tangent.
Curvature (%)Default 2 %: the curvature jump allowed on a tangent edge, as a share of the larger side’s curvature. Faces flatter than ten times the part’s size count as flat.
Sharp above (°)Default 5°: edges meeting at more than this are deliberate, not kinks.
Show sharp edgesAlso draws the sharp edges (grey).
Open edges against other bodiesAn open edge of a surface body is checked against a touching open edge of another body: surfaces before you knit them.
Samples per edgeDefault 25 points along every edge; more find a local fault on a long edge.
Save report…Every edge as a CSV table: verdict, length, largest gap, angle and curvature jump, and where the worst point is.

The list and the detail view

The Task Pane lists every edge with its colour, number (as in the report), verdict, length, gap, angle, curvature jump and share, worst first. Click a column to sort by it; Show filters to the problems (G1, kinks, gaps), everything but sharp edges, or everything.

Click an edge in the list (or pick a single edge on the page) to see it in detail: hairs along the edge, as long as the curvature jump at each point (the angle on a kink, the gap on a gap), each in its own colour, and the numbers in the message. Double-click zooms to it.

Changing a tolerance judges the measured edges again at once; the samples per edge measure anew.

Compared with SOLIDWORKS

SOLIDWORKS gives numbers for the gap (Check: the largest edge and vertex gap) and for the angle (Deviation Analysis along the edges you pick); curvature it shows as pictures (zebra stripes, curvature display, surface curvature combs). Continuity Check adds the curvature jump as a number and judges every edge at once.

Good to know

  • Measured in the add-in from each face’s exact surface; whole parts usually take well under a second, large ones show progress in the status bar (Esc stops and shows what was measured).
  • Read-only: nothing is added to the feature tree, and the part does not change.